Lost Control Racing
DIGITAL DASHBuilder

Your engine. Your gauges. Our cluster.

Three platforms, one 12.3-inch widescreen cluster: carb-and-senders, Holley EFI, or GM E38. Pick how your engine talks, choose the artwork, and send us the build sheet. The preview is the real LCR artwork running a demo pass.

Warming up the cluster

Demo values, not a live feed. Your final artwork is made by LCR from this build sheet for your 12.3-inch screen.

How does your engine talk?

Pick the one that matches what's under the hood. You can change it any time.

Three platforms, one cluster

PlatformHow it connectsWhat it readsBuilt for
Carb / AnalogLCR sensor module → dash, 20 Hz. Opto-isolated tach, pulse VSS, 0.5–4.5 V and resistive senders.RPM, speed, oil & fuel pressure, water & oil temp, fuel level, AFR, boost, nitrous, volts, indicatorsCarbureted street, strip and nitrous cars
Holley EFIRacepak CAN port · 1 Mbps · 29-bit extendedRPM, coolant, oil pressure, MAP/boost, AFR & target, timing, IAT, gear — plus more confirmed at installTerminator X, Terminator X Max and Dominator swaps
GM E38GM high-speed CAN · 500 kbps · 11-bit + OBD2 fallbackRPM, coolant, oil pressure, speed, PRNDL, volts, fuel level where the PCM has itLS3 / Gen 4 crate swaps, trucks and restomods

How it ships

  1. You send the build sheetPlatform, sensors, gauges and artwork from this page.
  2. We confirm your inputsSender part numbers, ECU, trans and tire size — anything marked "We calibrate" gets sorted here.
  3. We build and calibrateRanges, pulses-per-mile and sender curves set on the bench; artwork finished for your 12.3-inch screen.
  4. Install and first driveEvery build gets a setup check on your vehicle, and speed is verified against GPS.